How To Hammer In A Nail Correctly

2023 Author: Douglas Hoggarth | [email protected]. Last modified: 2023-05-24 11:23

Accurate nailing

A sheet of plywood or steel sheet will not only insure the surface of the part against accidental hitting it with a hammer, but will also serve as a guide for the nail being driven in.

Hard-to-reach nail

Hammering a nail in a hard-to-reach place will not be difficult if you use a simple device in the form of a bolt with a nut at the end.

Driving a nail into the spring bar

It is not easy to hammer a nail into a wooden spring bar that cannot be supported from below. The situation is facilitated by using a clamp instead of a hammer and using it to press the nail into the bar.

Driving in a nail without cracking

Driving a nail into the edge of the board, pre-compact the wood at the place of its hammering, slightly deepening the punch with hammer blows. This will prevent the board from cracking.

Strong connection

To make the connection strong, the nail must be of sufficient length and fit into the structure to which it is nailed by at least one third. To give greater rigidity to the boards to be hammered, nails are driven in at a certain angle to each other. It is easier to drive a nail into wet wood than into dry wood, since the elasticity of wet wood is reduced. In dense wood, the nail does not go well, it bends. In order to hammer it and so that it does not bend, it must be held in the middle with pliers.